Tuesday, August 28, 2012

Lectern Panel Prep

The lectern project is essentially to carcasses joined by an adjustable column. Each carcass is a dovetailed box sandwiched between two panels. Today I made some headway on the panels. The panels were marked out based on the carcasses +7mm, sawn, planed, and rounded over. 






There's still a little work to go. The bottom bottom panel needed a glue up to make the width. The top bottom panel will need a hole for column cut at 15 degrees.

No comments:

Post a Comment

Post a Comment

Like at Facebook

Redbubble